![]() ![]() ![]() But please read the safety instructions on page 2, then have a look through some of the features and details in this manual first. I could return the Onyx and get something else, but would prefer that as a last resort (got it a great bargain). to try out your new Onyx Blackbird 16x16 FireWire Recording Interface. I tried installing the latest FW SDK drivers, but no change in results.Īnyone have suggestions on what to try next? Mackie's phone support didn't really have suggestions, other than not using the 400-800 cable (which isn't an option since my iMac only has the one FW800 port). The obvious differences would be the OS and the FW connection (400-400 vs 400-800). so I believe the device itself is functional. I tried the Onyx on a MS Vista system (via 6-pin/4-pin cable) and it seemed to detect and work consistently. However, I can still only get signal from one of the boards instead of both. I was under the impression that I could chain the cards together in the Audio Midi Setup by creating a new Aggregate Device and selecting the two Firewire cards as that Device. This usually persists until I unplug the Onyx, or sometimes I get the beachball forever and have to force shutdown. I am using two Mackie Onyx 1640 Mixers with installed onyx firewire cards. But if I try to play any audio, or change any of the Onyx settings (e.g. When I plug this into my iMac (via 6-pin/9-pin cable), the Onyx shows up in the sound settings applet and is set as the default output device. I recently purchased a Mackie Onyx 1220 mixer with Firewire interface card. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |